Products
Showing 1 - 16 of 38 products
-
5,500.00
Sensors
This cyber-tronic looking sensor hides a secret behind it's glimmering eye. Unlike most temperature sensors, this sensor measures infrared light bouncing off of remote objects so it can sense ...
-
4,500.00
Sensors » Touch
FSRs are basically a resistor that changes its resistive value (in ohms Ω) depending on how much its pressed.
-
3,000.00
Sensors » Touch
This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to
-
10,000.00
Sensors
New! Version 3 comes with the latest module which has external antenna support and Pulse-Per-Second output
-
6,500.00
Sensors
This breakout comes with 3 analog outputs for X, Y and Z axis measurements on a 0.75"x0.75" breakout board
-
4,000.00
Sensors
The BMP183 is the next-generation of sensors from Bosch, and is the fraternal twin of the BMP180 - with a low altitude noise of 0.25m and the same fast conversion time. It has the same ...
-
4,000.00
Sensors » Flow
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2" (Nominal non-taped National Pipe) outlets.
-
6,500.00
Sensors » Pressure
This is a piezoresistive force sensor from Tekscan. The harder you press, the lower the sensor’s resistance
-
5,000.00
Sensors » Pressure
the Nintendo PowerGlove as a gaming interface
-
4,200.00
Sensors » Pressure
This sensor can detect bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.
-
5,200.00
Sensors
A gyroscope is a type of sensor that can sense twisting and turning motions. Often paired with an accelerometer, you can use these to do 3D motion capture and inertial measurement (that is - you can ...
-
2,800.00
Sensors » Proximity
This sensor is essentially a reed switch, encased in an ABS plastic shell. Normally the reed is 'open' (no connection between the two wires). The other half is a magnet. When the magnet is less than ...
-
4,000.00
Sensors » Touch
Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakout board,
-
3,200.00
Sensors
Infrared (IR) break-beam sensors are a simple way to detect motion. They work by having an emitter side that sends out a beam of human-invisible IR light, then a receiver across the way which is ...
-
3,850.00
Sensors » Flow
Measure liquid/water flow for your solar, computer cooling, or gardening project using this handy basic flow meter. This sensor sit in line with your water line, and uses a pinwheel sensor to measure